Way high-density pneumatic presses Troubleshooting What are

High-density pneumatic presses popularity more and more common equipment, which is characterized by compact and lightweight. However, a common problem in use is more, the role of performing the process of stamping a plurality of common aspects of the failure of the primary clutch, a crankshaft, abnormal sound, and guide screw rod and the like.

The following press us for that company technicians and high-density pneumatic presses together sum up the general failure and treatment approaches.

First, even play punch

1. The broken spring inside the sliding key, the replacement.

2. Slide button worn, want to change - new.

3 sliding key square bore wear becomes large, to be repaired

4. Check the contact separation where the foot switch

Second, the large abnormal sound clutch:

1. Adjust the brake tension.

2. Adjust the crankshaft screw tightness.

3. The clutch springs, "flippers" wear and tear.

4. Remove from NTU gear wear serious

Third, the clutch does not bind, does not disengage

1. replace the spring, the binding bond scrape gap.

Fourth, the crankshaft bearing fever:

1. bush scraping bad

2. Poor lubrication

Five burning rail

1. rail gap is too small, re-scrape rail, gap adjustment

2. Poor lubrication

3. bad

Sixth, strippers do not work to play material does not meet location:

1. Messenger adjusted manually rotated position of the flywheel back again.

Seven rod screw is turned, the head slider ball impact pad, the ball and the ball pad gland bad

1. gland screw loose

2. scraping ball, ball mat

3. tighten the gland screws.